Remote / water cooled condensing units

Remote condenser


Water cooled


Marine type water cooled


Sturdy heavy gauge galvanized steel formed base. 

The receiver is sized to hold the entire charge of the evaporator, condenser and liquid line refrigerant when the unit is in a pump down mode. (based on standard installations). Oversized receivers are available. A fusible safety plug on pressure relief valve and service valves is standard on each unit.

Located in a sturdy galvanized steel enclosure, built to provide easy access to every component, the control panel contains all the electric components. A pump down switch is mounted on the side of the box so it can be operated without the need to open the enclosure.

Kool-air will select the most efficient compressors, from a wide range of manufacturers to perform the work. Adjustable dual pressure controls (with flexible hoses), crankcase heater (outdoor unit), and rubber or spring mounts are standard equipment.

Optional equipment:


  • Soldered or replaceable liquid line kit (dryer & sight glass)
  • Solenoid valve
  • Suction accumulator, regular or with boil-out coil
  • Suction filter, soldered or replaceable
  • Oil separator
  • Oil level control device (parallel)
  • Main suction and liquid valves
  • Hot gas defrost kit
  • Oversized receiver
  • Suction to liquid heat exchanger
  • Adjustable head pressure controls
  • Custom color paint for housing
  • Factory installed pressure gauges
  • Hot gas by-pass valves
  • Discharge line muffler
  • Heat reclaim valve
  • Condenser water valve (water cooled)


  • Auxiliary contacts
  • Phases monitor
  • Electrical defrost kit with fuses and evaporator(s) contactor(s)
  • Defrost timer
  • Non fused disconnect switch
  • Fused disconnect switch
  • Fan cycling (2 or 3 fans) for outdoor units

See specifications

See manual